Tricks of the Trade

To keep stock from slipping when using my miter gauge, I rely on this simple jig. Screw a 3/4″ x 2″ fence to your miter gauge. Make it whatever length...

My finishing turntable is perfect for spraying large parts or projects. To make the device, I mounted five fixed 3-1/2” casters on a plywood panel. They’re equally spaced in a...

I’ve been noticing a lot of new tools these days that come equipped with on-board task lighting. Then while recently perusing my local home-improvement center, I noticed these small battery-operated...

Trimming small parts on a table saw using a miter gauge can be a little nerve wracking. In order to trim small parts safely, I mounted a handscrew to a...

My lathe tool rack is based on a fishing rod rack that I made some time ago. Made from 3/4-in.-thick walnut, it measures 3-1/8-in. by 10-in. by 30- in. I...

My bandsaw’s blade-tensioning system used to be wobbly and difficult to turn. Instead of shelling out for a quick-release lever, I came up with this simple, inexpensive fix. To stabilize...

Adding a hold-down to my shop-made crosscut sled makes the sled easier and safer to use. My parts don’t slip and my fingers are far from the blade because I...

Finding a felt-tip marker or touch-up stick that actually matches the color of your project is a real crapshoot. What if you could make your own, using your own stain?...

Here’s an easy way to cut bowl blanks from half log sections. Cut a round guide disc from 1/4″ thick material the size you want your blank to be, and...

I really like my round Veritas bench dogs because they’re so versatile and easy to install. The only problem I have with them is raising the less accessible ones when...

Over the years I have used about every type of marking gauge made. I prefer the newer wheel gauges because they’re easy to adjust and tighten, but I think they’re...

Using a tablesaw to cut rabbets on the end of a board is nothing new.  If you’ve only got a couple to make, it’s hardly worth the time it takes...