Pants on Fire When Daylight Savings Time begins, I make it a point to change the batteries in the three smoke detectors in my workshop. It was that time again,...
While turning wooden pens, students in my woodshop classes kept wearing out the points on the live centers of our mini lathes. The points fit into the hollowed end of...
Filling knots with colored epoxy usually works quite well, but sometimes the void is in a spot that’s difficult to fill, like the edge of a board. Here’s how to...
Mice used to rule my shop. They got into everything! That all changed when someone told me that fresh mint repels mice. Mint grows wild in one corner of my...
Chamfering an edge with a block plane is often easier, faster and safer than using a router or tablesaw—particularly on a small part. I do it so often that I’ve...
Here’s a simple way to sharpen chisels using a 3″ sanding drum mounted in an oscillating spindle sander or a drill press. Cut a squared-up 2×4 the length of the...
Dust is a real problem when you can’t use a router table’s fence and its dustport. Here's a clever way to suck up that dust using your shop vacuum's nozzle.
My lathe came with a lamp, but the lathe’s manual has this weird warning: “Position the work lamp so that wood chips do not accumulate inside the lamp shade and...
For small cabinets, I prefer to use small, discreet shelf pins that I make myself. I also make sleeves for the pins to fit into. Sleeves help hold the pins...
Flush-cutting dowels, corner keys or screw-hole plugs used to frustrate me because my saw’s teeth always left scratches on the project’s surface. Rather than buy a special flush-cutting saw, I...
I used to have three shooting boards for planing end grain: one for 90° cuts, one for 45° horizontal miters and one for 45° vertical miters. Now I’ve combined them...
An F-style clamp works well for getting into tight spaces, but how do you turn the handle? The answer: Just drill a couple of holes through it and insert a...
