Sometimes drilling a hole in a finished piece of wood is unavoidable. I keep a pad of sticky notes nearby for this purpose. I put the sticky note roughly over...
Quick Panel-finishing Setup When making frame-and-panel doors, my panels are finished before installing them into their frames. The fact that the edges will be tucked into the frames allows for...
I used to struggle making Dutchman keys (also known as butterflies) – but I love using them in my furniture. So, I came up with an idea that works well...
If you have an adjustable countersink bit (like the ones from Insty-Bit), you can loosen the set screw and pull the collar off, then flip it around so the flat...
There are times when you need to hold a workpiece securely against a dog in the workbench, but don’t want to risk damage to the work from a hard bench...
When I had to install a bunch of magnetic catches recently, I came up with this simple method to mark the doors for the strike plate. It requires no measuring...
Planing the edge of a long board perpendicular to its face is a real challenge. To make the job easier, I built a guide that attaches to the side of...
I make lots of lazy Susans in my cabinet business, so I cut circles of many diameters. Changing diameters is easy on my circle-cutting jig, because I use a pop...
Nothing makes a cabinet look worse than door panels with unattractive grain that runs at werid angles. It pays to be picky about grain direction, even it means wasting some...
I enjoy making picture frames but always found it a pain to use tacks or staples to hold the picture in place. Plus tacks and staples are hard to remove...
