In Projects, Questions And Answers, Techniques

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

How Can I Avoid Kickback
When Resawing on a Tablesaw?

 

Q:

Is there a splitter that can be used for resawing on a tablesaw? Mine is hooked onto
the blade guard so it won’t work.

A:

It’s unfortunate but true; you can’t use a conventional splitter for resawing on a tablesaw.
But,what you can do is glue a hardwood splitter into a zero-clearance throat plate. Just
extend the opening in the top of the plate with a shallow 1/8-in.-wide dado and glue in a
wedge of hardwood.The wooden wedge keeps the kerf open so it can’t pinch the blade
and cause a kickback.

It’s essential that the splitter be aligned precisely with the saw blade.Here’s how
to do it: Lay a zero-clearance throat plate upside down on your saw with the blade
extending up through the slot. (Be sure to have another throat plate in the saw.)
Set the fence against the edge of the throat plate, lower the blade and make
a 3/16-in.-deep cut. Glue the hardwood splitter into the
slot. Sand the wedge so it’s a
touch thinner than the blade
kerf and sharpen the leading
edge just a bit.Now you won’t
have to sweat the dreaded
pinch when you resaw.

This story originally appeared in American Woodworker October 2002, issue #96.



October 2002, issue #96


Purchase this back issue.

 


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recommended Posts
0

Start typing and press Enter to search