We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.
When i made that Floating top table, I had an extra 1x8x6' pine board. Needed a small project for this board. I came up with a "chair' of sorts, called a "Pouting Chair". Although this one would be a bit small, one could put a doll or some other figurine on the seat. Simple butt joints, with plug-covered screws. Mostly done on the bandsaw. A few pictues of this little chair ( remember, this is out of just a piece of 1×8):
A sideview:
front view:
under the seat
sitting in a "real" chair. I kept some of the cut-outs, to provide stock to make plugs with. Those screw holes showing in that last picture are covered up with the plugs from the same board. Nothing is wasted here.
