Archives

I found yet another use for my trusty speed squares. Just clamp one or two of them inside the corners of a cabinet when you’re gluing it up. This guarantees...

When gluing miters for small mouldings, clear packing tape makes an ideal clamp. Begin by placing a strip of tape across the bottom of the joint; this will prevent glue...

Tool: Bench Cookie Shop Now  Manufacturer: Rockler MSRP: $12.99 (set of four) These aptly named bench cookies are clever and inexpensive problem solvers. A set of four elevates a board...

I made a built-in bookcase for my daughter that required attaching the face frame after installing the case. I didn’t want to mar the face frame with nail holes, but...

For years, I sanded and hand planed panel edges by laying them flat on my workbench.  I could never quite squeeze a bench vise into my woodworking budget, so I...

“You can’t have too many clamps,” a wise cabinetmaker once said. That is certainly true, but in a small shop, you can easily run out of room to store them....

Last week I showed how to source and install a missing swivel pad over the ball of a clamp’s screw. That kind of pad only works in a ball and...

I recently was gifted a few old bar clamps from a fellow member who belongs to our local FreeCycle group. FreeCycle.org is an internet-based group that promotes the free exchange...

Oxalic acid makes black marks disappear. Nasty stains can occur during glue-up if steel clamp beams are left in contact with wood dampened by glue squeeze-out or by scrubbing off...

After years of wishing my old workbench had a tail vise, I realized I could make one of my new Jorgensen Cabinet Master bar clamps do the job. All I...

I lost the rubber pads that came with my clamps. I liked the way the pads protected the wood, so I decided to make my own. After a couple dips...

I needed a way to secure the tail board on the pin board for marking on a large case project while transferring the layout. So, I used two picture-frame clamps...