We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.
By Robert W. Lang
Page: 29
From the April 2005 issue #147
Buy this issue now
The combination of an oscillating spindle sander with a 12″ disc sander makes a lot more sense than the usually seen belt and disc combination. Here are two tools that you will really use. Both functions share a single 1-hp motor and stand. The spindle moves up and down at 60 strokes per minute and is ideal for smoothing concave curves. Four different sizes of spindles are included, along with appropriate table inserts, and all of these have built-in storage slots on the base.
From the April 2005 issue #147
Buy this issue now
