In Shop Blog, Techniques

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

square_clamped_IMG_6690

During the last several years I’ve built about 50 wooden try squares for customers, friends and during classes. The most challenging part of the project is clamping the blade and the stock together so they are square.

I have tried three or four clamping strategies – some of them too involved to discuss here. By far, the best way to do it is the simplest.

Here is my procedure:

1. Use hide glue and don’t peg the joint between the stock and blade. If the square gets damaged or goes badly out of square, it’s easier to disassemble the parts and fix the problem than it is to fix the problem on an assembled square.

2. Tape plastic wrap to a known flat surface, such as your workbench.

3. Spread the glue onto the cheeks of the bridle joint in the square’s stock. Push the blade into the bridle joint to smear the glue on all surfaces.

4. Clean off any squeeze-out with a rag and warm water.

5. Place the stock on the plastic with the blade pointing to the ceiling. Clamp the joint gently. Very gently.

6. Put a known square on top of the stock and nestle it into the right angle created by the stock and blade.

7. Tap the blade until it is dead square when compared to your known square. Tighten the clamp a little more. Watch the two squares. Clamp the joint firmly. If the blade moves, loosen the clamp pressure and shift the blade.

8. Remove the “known square.” Walk away. Don’t mess with the clamp or square for several hours.

When I follow the above procedure I usually don’t have to do butkus to square the square. If there is any error, it is usually remedied by removing a shaving or two from the blade.

— Christopher Schwarz

Want plans to build the Roubo try square? You can download the plans for the square here from ShopWoodworking. This is one of my favorite shop tools.


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recent Posts
Showing 4 comments
  • tsade

    My Yiddish grandmother just turned on her side in her grave. (Not worth a full turn.) Unless you’re channeling a certain football guy, that would be “bupkis” to you. You’re welcome. ;>)

    Tony

  • roger23

    chris I was trying to find a download for the roubo try square is there one so I can make some for the shop

  • rwyoung

    The plastic cases CDs come in are pretty dang square. The rigid ones, like you got in 1997 when you bought that Elton John CD (we know all about the dancing in the moonlight to “Candle In the Wind”). These work great as references for making smaller squares if you don’t already have a good reference.

Start typing and press Enter to search