Archives

I had to crosscut narrow strips to make a cutting board. The boards were too wide for my miter saw, so I decided to use my tablesaw’s crosscut sled. I tried a standard stop, but after a few [...]

An accurate inside measurement is sometimes difficult to obtain. For example, I needed to take a measurement behind a cabinet’s face frame to fit a new shelf. Typically, most people would [...]

Face jointing boards requires some safety precautions to keep your fingers out of the danger zone. I made this simple push plate with a cleat on the back end. Two handles allow me to apply [...]

Making through-slots without a router may sound tricky, but it couldn’t be easier. In the days before I could afford a router, I made through-slots by gluing up scraps instead. Here’s [...]

PVC spring clamps aren’t new. I like using them, but thought they could use some improvement. Here’s what I came up with. First, I added two dowels installed 90° from each other (into [...]

Rare earth magnets set in a steel cup are perfect for all sorts of uses around the shop, but have you ever had to remove one? Once they’re in the cup, the magnets are practically impossible [...]

Monitoring the level of dust in your bin is a pain. You have to remove the lid and look, which isn’t easy. If you forget or put it off, dust will back up into the collector’s main [...]

Making equal divisions on parts isn’t always straightforward when it comes to dividing fractions. On a recent trip to my local office supply store, I found a drafting tool that has become a [...]

Featherboards are an important accessory, providing both accuracy and a measure of safety. Typically, a featherboard is just a board with thin fingers sawn into the end that act as springs to [...]

Resin build-up on saw blades makes them less effective. A clean blade runs cooler, doesn’t cause burning on your workpiece, stays sharp longer and cuts more accurately. Cleaning blades is a [...]

Carrying a cutting list with me to the saw is a habit I learned long ago. If I don’t, it’s way too easy to transpose measurements on the way from my bench to the saw. I used to carry a …

Bar clamps can wear out over time. Usually, it’s because the ridges on the bar get worn down. When this happens, the clamps lose their grip, rendering them useless. Even if it’s just [...]