Projects

Modular Desk System Mix-and-match components make a desk that fits your needs. By Bruce Kieffer This computer-desk system has more going for it than great looks. The system is based...

Tablesaw Jig Clamp I added this hold-down to my tablesaw’s sliding cutoff jig and find it a great convenience, because the height of the clamp is easily changed. This clamp...

We are nearing the end of this multi-part series. Perhaps two more installments and we will be done. To put this project in context I thought it might be helpful...

Why Predrill Screw Holes?   Q: I think predrilling screw holes is a real drag, so I rarely do it. Most screws seem to work fine without all that bother....

European Hinges German engineering results in a clean look, simple and predictable installation and three-way adjustability. By Jim Grandbois Once I discovered the simplicity of hanging doors [...]

Tablesaw Storage Cabinet All of your tablesaw accessories close at hand By Eric Smith The last time I could find them all, I counted 18 accessories for my tablesaw. Dado...

Cool Tip for Changing Sanding Sleeves Changing the sanding sleeves on a spindle sander can be as tough as removing an old rusty bolt. Next time, try this trick: Put...

Note: If you missed my first post on this magazine stand, you might like to begin here. I may be overly fond of pattern routing, because any time I have...

Glove Finger Chisel Protectors My Chisels used to get dull and rusty rattling around in my toolbox. No more! I found a clever way to protect them. I cut the...

Prescription Safety Glasses   Q: I hate fumbling with goggles over my prescription glasses, so I’ve given up. Don’t regular glasses protect my eyes well enough in the workshop? A:...

Turning Bocce Balls By Alan Lacer Freehand turning of a near perfect wooden sphere without flat spots or bumps is a wonderful challenge for a turner.Whether it’s for croquet, furniture...

Rigid Routing Sled A routing sled is a great help when coping the ends of rails and stiles. But I had a problem when I built my first sled. The...