Archives

Carter MagFence II By Brad Holden If you've been thinking about replacing your bandsaw’s stock fence, it doesn’t get any easier than switching to the Carter MagFence II. [...]

Kreg Precision Router Table Setup Bars By Brad Holden Accurate tool setup is half the battle of doing good work. Kreg’s Precision Router Table Setup Bars make the battle a...

Precision Sliding T-Bevel By Brad Holden How accurate can you be if you use a protractor to read the angle of a sliding T-bevel? A degree or two? How about...

Next month, the North Carolina Museum of History in Raleigh, N.C., will open a shop of later 20th-century woodworking iconography titled: “Blood on the Adze: The Hegemony of Post-radicalist [...]

Don’t miss Woodworking in America – Don’t miss Chuck Bender     Also, check out Chuck Bender’s great DVDs: “Dovetail Mastery” “Down and Dirty [...]

In many museums, the best stuff isn’t out on display it is tucked away in the basement or in the hands of conservators. The J. Paul Getty Museum in Los...

Clean Rusty Tools by Electrolysis Electrolysis is a gentle, safe way to chemically remove all the rust from small tools, and it leaves the iron untouched. An abrasive can remove...

  Cutting Gauge Tune-Up Q: I bought a new marking gauge to cut across the grain when I lay out tenon shoulders and dovetails. The problem is, it doesn’t make...

While I have a blister on my right hand from wielding a saw and mallet (alternately, of course) for five hours, I’m delighted to report that I now have the...

Rubbish tip that had alot of 4×1 and 6×1 timber .Needed alot of sorting out .But in the end it was worth it. A dog /pet bed was made ....

After contemplating all my different design ideas, I decided to start with the basics and make a prototype. This called for a a simple piece of wood shaped like see-saw. [...]

The dovetailed skirt around the carcase of a tool chest (or blanket chest) is fussy to fit. The case has to be square and plumb. The skirting material has to...