Shop Blog

Greene & Greene (G&G) breadboard ends are never flush with the edge or top of a table top.  This proud look is then capped with a polished Ebony spline embedded...

We had some great videos this week, thank you all for submitting the best woodworking videos! I’d like to draw special attention to Simple Cove’s video series on building a...

There are a lot of people who don’t see the point of having a panel-cutting sled, which is a sled that has its fence on its leading edge instead of...

I recently finished a fun serving tray project with shop scraps. It features a decorative bottom covered with a bar top finish. You can pretty much build this to any...

I’ve enjoyed building Arts & Crafts furniture for a number of years. The look of the quarter-sawn oak after finishing has always been a strong selling point – a common...

No, you have not entered an alternative dimension. Today – on this blog that focuses on handwork – we are going to talk about table saw sleds. When I do...

Blame it on the martini I had the night before. Or maybe on the dribble of eleventh-hour requests for illustration proofing related to my forthcoming book on English Arts &...

First, I’d like to say, I didn’t mean to pick all walnut build videos this week. It just sort of happened and we didn’t notice it until we were in post-production....

After the death of Nancy Cogger of Londonderry Brasses, Horton Brasses acquired the company’s stock and is selling many existing pieces at 50 percent off. Orion Henderson estimated there are...

WorkbenchCon, A brand new maker conference, kicks off tomorrow and runs through Saturday in Atlanta, Georgia. It represents a departure from the woodworking show model of vendors and [...]

Recently I needed to install two thumb screws into a makeshift fence that was intended for my petite table saw. By threading a hole in the wooden fence I was...

I built a folding bookstand (above) for an upcoming issue of Popular Woodworking Magazine that uses traditional copper rivets to join the components and allow them to pivot. After posting...