Archives

Just some of the toys I make do with My "big" drill press The "Frankensaw", two craftsman tablesaws were used to make this saw.    One a broke trunion saw, the...

When i made that Floating top table, I had an extra 1x8x6'  pine board.  Needed a small project for this board.   I came up with a "chair' of sorts, called...

To make that Reindeer: Basically, just four different kinds of parts, you'll need to make two of the front and back legs a body from that 1×6 Antlers, note the...

For a Sleigh and a reindeer? out of 1/2" thick pallet slats for a sleigh? just some nails, glue, and an 1/8" dowel or maybe a scrap piece of 1×6...

Picked up some boards that were thrown away at a remodel project down the street and I needed a railing for a front porch and ripped a few boards down...

Details of the end panels and the top's frame the 'wood pile', from old barn siding, most of this went into the end panels Drawer construction, just dovetails on the...

glue-ups, end view Top and bottom shelf added All the parts, but the plywood shelf from water bed frames, to this Which's Brew Walnut stain.   Size is 16" wide(top)  by...

Glue ups with some of the arms in place Parts, two top rails, a spindle shaped, a foot and an arm Fitted up, posts were turned on on my lathe...

Drawer parts, awaiting dovetails, face frames screwed in place with plugs over the screws. with some finish on them Back side of the drawers, the screw is a drawer stop,...

In place, will be stained to match tool kit, this is mostly what I used Locations marked out, showing the defects to be covered up A single one on an...

"Front View" "Dutchman" on bottom apron, covering an old bolt hole shelving:  center divider is notched to the middle shelf, just a slip fit in a notch in the shelf...

end panels web frames details of the frames face frames and drawers.  Top in place Details of top's frame, showing a center stretcher.  Plywood top sits in the rabbet around...