Archives

Achieving a glass-flat surface is a lot easier than you might think. By Bob Flexner Pages: 79-83 From the August 2006 issue #156 Buy this issue now After spending countless...

Don’t let the dizzying array of choices get you discombobulated. By Bob Flexner Pages: 90-93 From the June 2006 issue #155 Buy this issue now Go to any home center...

Understanding just a little chemistry will teach you a lot about this finish. By Bob Flexner Pages: 90-92 From the April 2006 issue #154 Buy this issue now At a...

Don’t be a drip – learn how to keep your equipment in fine working order. By Bob Flexner Pages: 98-99 From the  February 2006 issue #153 Buy this issue now...

If you want to spray finishes indoors, you need an exhaust system. This affordable homemade set-up makes it possible and affordable.

Sometimes it’s a good technique for repairing damaged finishes. By Bob Flexner Pages: 102-104 From the November 2004 issue #144 Buy this issue now In the woodworking community, French polishing...

Leaving the underside of your tabletop bare doesn’t cause warping. By Bob Flexner Pages: 110-111 From the October 2004 issue #143 Buy this issue now Logic is usually a good...

These products are easy to apply with good results – choosing the right one for the job is the hard part. By Bob Flexner Pages: 86-87 From the August 2004...

Achieving a glass-flat surface is a lot easier than you might think.

Understanding how sheen works allows you to control the gloss on your finishes.

One of the oft-forgotten tools in finishing is glazes. Here's how to get started with this handy technique.

For small or specialty jobs, spray-can finishing is a good choice.