We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.
When i made that Floating top table, I had an extra 1x8x6' pine board. Needed a small project for this board. I came up with a "chair' of sorts, called a "Pouting Chair". Although this one would be a bit small, one could put a doll or some other figurine on the seat. Simple butt joints, with plug-covered screws. Mostly done on the bandsaw. A few pictues of this little chair ( remember, this is out of just a piece of 1×8):
A sideview:
front view:
under the seat
sitting in a "real" chair. I kept some of the cut-outs, to provide stock to make plugs with. Those screw holes showing in that last picture are covered up with the plugs from the same board. Nothing is wasted here.
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
