<img height="1" width="1" style="display:none" src="https://www.facebook.com/tr?id=376816859356052&amp;ev=PageView&amp;noscript=1">

DeWALT Miter Saw Recall

DeWALT is recalling nearly 1.4 million miter saws for a potential safety issue. According to the CSPC “The miter saw’s rear safety guard can break or detach, posing an injury hazard due to [...]

Protecting Tools from Kids

Sometimes a little talking-to (and video surveillance) is all it takes. I have noticed three things about tools and kids. Kids can find tools even if it requires tunneling under the garage wall. [...]

Efficient Shop Wiring

A single cable provides 120-volt and 240V service. Every article I’ve seen describing the wiring of a shop for both 120 volts and 240V uses separate cables for each voltage, which is a [...]

Make Your Own Blast Gates

They’re cheap! All you need is some PVC and plastic laminate. A central dust collection system is a big improvement to any shop, but the cost can really add up. With commercial gates going from [...]

Working Safely in the Shop

Safety is the #1 goal in woodworking. June is national safety month, so we’re covering some shop safety best practices. Learn about avoiding hazards while woodworking, as well as the [...]

Glove Finger Chisel Protectors

Here’s a simple way to protect your chisels from getting nicked and rusty rattling around in your toolbox. Just cut the fingers off some old leather work gloves. Poke holes with an awl at [...]

ISOtunes FREE Aware Review

Tool: FREE Aware Bluetooth Earbuds Shop Now  Manufacturer: ISOtunes MSRP:$199.99 I’ve written before about the impressive ISOtunes Aware headphones, which use a built-in microphone [...]

Woodworking Safety 101

Seasoned professionals also benefit from woodworking safety. Regardless of your experience level, it never hurts to review the basics. In fact, I believe there are a number of standard safety [...]

Improved Push Pad

Ordinary push pads tend to slip, I’ve found, when face-jointing a board. I modified one of mine by cutting 1/2″ of the rubber padding off its back end and then screwing on a 1/2″ x [...]

Adjustable Push Shoe

A push stick is a familiar device to prevent kickback while ripping a board, but I prefer to use a “push shoe.” It’s shaped like a shoe with a handle, and has a heel, just like a boot. The [...]

Easy Cord Management

Trailing along a power cord when I’m routing can really be awkward. All too often, my cord hangs up on a corner of the project or gets tangled around my legs. Adding a dust collection hose, which [...]

Start typing and press Enter to search