Archives

When I need to cut a bunch of small, equally sized pieces, I install this simple jig. It holds short pieces securely during and after cutting, so they don’t get caught by the blade and thrown [...]

Pattern-Cut Finials The traditional way to make a square finial on a bandsaw is to mark and cut the pattern on one side of the blank, then tape the offcut back on to the blank in order to guide [...]

When applying laminate on a narrow edge, it’s a little tricky to not tip the router and undercut the edge. The surface on which the router must balance is often not wide enough to provide [...]

This accessory will rise to the occasion to make cuts safer and easier. By Nick Engler Pages: 28-30 From the June 2004 issue #141 Buy this issue now Now and again you may have to turn a board on [...]

Turn your laminate trimmer into a tool that flushes surfaces with incredible finesse. By Nick Engler Pages: 34-35 From the April 2004 issue #140 Buy this issue now Once upon a time I had the [...]

Get extra outfeed space without sacrificing precious floor space. By Eric Hedberg Pages: 84-85 From the August 2006 issue #156 Buy this issue now Who says that table saws aren’t “hip?” This [...]