Work in Tight Spaces without Special Tools
When you have to work inside a carcase, there are a wide variety of specialty tools on the market – such as right-angle drills and drawer-lock chisels – to make your life easier.
I try to keep a small tool kit. Not because I’m a tightwad. I’m not. But I travel a lot and I prefer to have fewer tools to take care of and keep track of. Buying fewer tools also gives me more money for wood and beer.
Here are a few of my favorite tricks for working in tight spaces with regular tools.
1. The ‘goberge.’ One of the toughest things about working inside a carcase is when you have to glue and clamp something in the middle of the case. Sure, you can buy some crazy expensive deep-throat clamps. Or hope that a nail or screw will do the trick. I prefer the “goberge” – usually called a “go bar” in this country.
It’s a stick that is slightly longer than the space in which you need to apply pressure. The corners are chamfered a tad with a chisel. This allows the goberge to get wedged inside the case. Then you tap it with a mallet until you have the pressure you need.
This is a very old trick – the earliest place I’ve seen it was in a 17th-century French text.
Many woodworkers and piano makers use these goberges against the ceiling for applying pressure to the middle of panels on the bench. (Note this will not work with a modern drop ceiling or drywall ceiling. You have been warned.)
2. Butt chisels. I’ve never owned a butt chisel. Instead, I have socket chisels and remove the handle when I need to chop inside a tight space. Rap the handle hard against the bench a few times and the socket will release its hold on the handle. To reset the handle, put it in its socket, hold the socket and hit the butt end of the handle against the bench.
If your handle comes loose too easily, spray it with a squirt of hairspray – yes, hairspray. Let it dry for 10 seconds and then drive the handle on. The hairspray will allow you to remove and reset the handle many times before having to respray the handle. In other words, you don’t have to have a bottle of hairspray in your tool chest.
3. Hand drills. I use a hand drill for almost all of my small-diameter holes. When installing locks inside small cases or doors, it can be hard to get any drill in there. So I unscrew the handle and get to work. Not all of the handles unscrew, but many do. If you are in the market for a hand drill, look for one with a removable handle. (No, I don’t have a list of models and makes to guide you. You are on your own.)
4. Japanese nailset. If you don’t have a nailset, consider getting this inexpensive one. It’s available everywhere. The two heads allow you to get into tight spaces. You can easily grind or file the other tip to suit your work.
5. A file handle. An old book called “Jobbing Work for the Carpenter” by E.H. Crussell convinced me to pick up one of these for a few bucks at a tool meet. I love it. When it comes to improvising in the shop, this is your best friend. Don’t have a scratch awl? Clamp a nail in the handle. Need a birdcage awl? Clamp a cut nail in the handle. The chuck of the tool will hold a surprising range of items – knife tangs, burnishers, jigsaw blades, countersinks.
— Christopher Schwarz