In Questions And Answers, Techniques

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

Hone a small bevel on the back side of a rusty blade…

... to quickly get down to clean steel.

… to quickly get down to clean steel.

Q: I’ve got an old plane that my grandfather left me. I’d like to use it, but its cutting iron is really rusty. Do I need to buy a new one?

A: Don’t throw away that iron yet. Flattening the back of a plane iron is usually the first step in sharpening, but you might spend hours to get down below the rust pits to clean steel.What a chore!

Here’s a non-standard method that could rescue your antique plane iron. Rather than flatten the entire back, work only on the leading edge to create a very small, low-angle bevel. This will slightly increase the cutting angle of the plane, but you probably won’t notice the difference.

The catch is that you must hone this back bevel at a consistent angle every time you sharpen.Use a standard honing guide to sharpen the main bevel of the iron and simply turn it upside down to create the back bevel. If you prefer to sharpen without a guide, you can create the back bevel by laying a shim on top of your stone. The shim slightly raises the blade the same way the guide does.


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recommended Posts
0

Start typing and press Enter to search