AW Extra 6/12/14 – Better Winding Sticks
Better Winding Sticks
Winding sticks are very useful for gauging twist in a board, but they’re difficult to read. My improved version of these time-tested helpers makes the twist stand out.
I start with a pair of straight, flat 2-in.-wide sticks made from 3/4-in.-thick light-colored wood. Then I stain both of them dark—the darker, the better.
When the stain is dry, I cut shallow rabbets in both faces at the top of both sticks. This exposes a ribbon of light-colored wood above the stained surface on each face. To cut the rabbets, set the blade’s height to 1/2 in. and the rip fence 1/32 in. narrower than the stick. Rip all four rabbets from this setting.
Joint the top edge of one board to remove the stain. Then rip this board narrower by the width of the rabbet on the other board. That’s all there is to it.
During use, the narrow stick goes in front. Any twist in the board shows as a dark-colored wedge between the top of the rabbet on the near stick and the bottom of the rabbet on the far stick.
This story originally appeared in American Woodworker August 2006, issue #123.