In November 2009 #179, Popular Woodworking Magazine Article Index

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

ladders form the base of this knockdown desk — simple steps to a higher education in woodworking.
By Hunter Lang
Pages: 58-62

From the November 2009 issue #179
Buy this issue now

I’m in the midst of preparing for college, so I need a desk that is functional but also portable, so that I can easily move it into my dorm room when the time comes. The desk that I’ve had since I was nine years old is too small and about to fall apart. It wouldn’t be worth it to take it to school with me. So I decided to build a new one.

This new desk was designed with a large top to hold a computer monitor and still have enough space for book work. It was also designed to be easily taken apart and put back together. Slots in the rails of the shelves fit on top of the rungs of the ladders with a few screws for added stability. This design would be ideal for any college student, and meets my needs perfectly.

I began building the desk by cutting 1 1/4″-diameter poplar dowels to 20 1/4″ to be used as connectors for the ladders. Then I made tenons on each end at the router table, with a 1/2″-diameter straight bit with 1/8″ of the cutter exposed above the table. To keep each dowel centered over the cutter, I clamped blocks on each side of the bit and set the fence on the router table back from the front edge of the cutter by 7/8″.

I moved each dowel into the cutter and rotated it with my right hand as I held it down with my left. As the cuts were made I moved the dowel toward the fence until I had made a complete rotation with the end of the dowel against the fence. This gave me a tenon on the end with a 1″ diameter – that’s long enough to go through the legs of the ladders.

After preparing the tenons, I cut the angled leg pieces to length and laid out centers for holes according to the drawing on page 60. I grouped the legs in pairs and marked off the locations for the holes and the angles on the ends of the legs. Then I drilled the holes with a Forstner bit at the drill press, using the fence to center the holes in the legs.

Online Extra

* Click here to download the 3D Google SketchUp model of the Knockdown Computer Desk.

From the November 2009 issue #179
Buy this issue now

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recommended Posts

Start typing and press Enter to search