One of my favorite advertisements shows a guy with a handsaw staring at a chair that has legs that are about 4″ long. In his efforts to stop the chair from wobbling, he kept cutting down the legs until they would look about right if they were attached to an opossum.
(The ad is a complete failure, however, because I cannot for the life of me remember what they were selling.)
In any case, I was taught years ago a method of leveling legs that hasn’t let me down. Today I had to level the legs of the next “I Can Do That” project I built for the April 2010 issue of Popular Woodworking. It’s a rustic Swedish bench from the Skansen living history museum in Stockholm.
Step 1: Level your work surface. You need a flat and level surface to true up the legs of a chair or bench. At my shop at home I’ve leveled my table saw (which also helps keep its sliding cutoff table working well). Here I’m leveling Megan’s workbench with builders’ shims and a long level. Check along the length and the width of your surface. Megan is out sick today so I annexed her workbench. Neener neener, Megan.
Step 2: Level the top of your project. Place the project on the work surface and get the top of it level , if you want it level. Many chairs lean backwards. If you want the chair to lean backwards, level the front two legs to the work surface and shim under the feet until the chair is level side-to-side and slopes backwards as you desire. In this case, I wanted the top level. So I shimmed under the feet until the top of the bench was level across its width and length.
Step 3: Shim the feet. I use builders’ shims if there’s just a little wobble. Big wobbles require blocks and/or big shims.
Step 4: Set your scriber. Now open your compass so it matches the largest gap between the feet and your work surface. Note: You can also cut a block of wood to this same width and achieve the same result.
Step 5: Scribe around the feet. Run the compass around your feet, scribing the finished length all around. If you are using a block of wood instead of a compass, use that block of wood like a ruler all around the legs.
Step 6: Saw or plane away the waste. If I have a lot of material to remove, I’ll saw to the lines. I prefer to saw the legs whenever possible. If I have only a little material to remove I’ll use a block plane. If planing, I’ll first bevel the foot all around down to the pencil line. Then I’ll remove the middle of each foot with the block plane (skewing and a little mineral spirits help make this easier).
Step 7: Check your work. Use a straightedge or ruler to confirm that the feet are in the plane you desire. When they are, turn the project back over and test your work with your butt, which is very accurate (I have Starrett-brand buttocks!).
The total elapsed shop time for this operation is usually about 15 minutes.
I’m sure there are other ways to do this (I’ve seen some ridiculous methods in magazines, including ours). If you have a better way to do this, let us know.
– Christopher Schwarz
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.