In June 2008 #169, Popular Woodworking Magazine Article Index

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

Two tricks for taming miter joints.
By Robert W. Lang
Pages: 28-29

From the June 2008 issue #169
Buy this issue now

Learning a new skill is often a matter of getting past the scary part. If you can reduce the number of things that can go wrong, you become comfortable enough to push past what once seemed an insurmountable obstacle. Miter joints are never a walk in the park, but they don’t have to be a middle-of-the-night trip through the cemetery.

A four-sided frame or box is the usual starting point for mitered joinery. In this scenario, the beginner will likely be frustrated by tiny errors in the degree of angle or the length of the parts. Any errors made will show up in the last joint to be closed.

At this point errors aren’t tiny any more. On a square frame with 12″ sides, even with only 1?10° of error, the gap at the last corner will still be 1/8″. The degree of perfection required is obtainable, but there are two other hurdles to overcome for successful mitering.

This I Can Do That project addresses the two problems that can cause even perfectly cut miters to fail: Getting a strong glue joint and clamping the corners together. There is a simple solution for each, and knowing these will make getting perfect corners easier.

From the June 2008 issue #169
Buy this issue now

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recommended Posts

Start typing and press Enter to search