Flexner on Finishing: Finishing Cherry - Popular Woodworking Magazine

Flexner on Finishing: Finishing Cherry

 In February 2009 #174, Popular Woodworking Magazine Article Index

Some straight talk about cherry and blotching.
By Bob Flexner
Pages: 70-72

From the February 2009 issue #174
Buy this issue now

When I opened my furniture-making and restoration shop in 1976, the woods considered best for high-end furniture were walnut and mahogany. Of course, oak and maple were also used, and sometimes cherry.

Washcoats: The left side of this cherry panel was washcoated, then Minwax cherry stain was applied to both sides (there is no stain on the middle stripe). Notice that the washcoat reduced the intensity of the blotching a little but didn’t totally eliminate it.

As had been the case through the previous three centuries, cherry was still thought of as the poor man’s substitute for mahogany. The coloring is similar, but mahogany had always been considered the higher quality wood. A large part of the reason is that mahogany colors evenly and cherry blotches.

Blotching is uneven coloring caused especially by stain penetrating deeper in some areas and leaving more color when the excess stain is wiped off the surface.

Times have changed, and cherry is now the favored wood with a great many woodworkers. Mahogany is hardly even considered for use anymore, and neither is walnut very popular. But cherry still has the blotching problem and everyone wants to know how to deal with it.

Read the full article here.


Recommended Posts

Start typing and press Enter to search