<img height="1" width="1" style="display:none" src="https://www.facebook.com/tr?id=376816859356052&amp;ev=PageView&amp;noscript=1">
 In Featured Article

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

Leaving the underside of your tabletop bare doesn’t cause warping.
By Bob Flexner
Pages: 110-111

From the October 2004 issue #143
Buy this issue now

Logic is usually a good guide, but it doesn’t always apply. A case in point is the widely held belief among woodworkers that the way to prevent warping is to apply finish to both sides of a board.

This practice does seem to make sense at the outset. Moisture exchange is responsible for warping, and a finish slows moisture exchange. So assuming the wood was properly kiln-dried to begin with, if the moisture leaving or entering the wood from changing humidity conditions is equalized on both sides, wouldn’t this prevent warping?

Not at all.

From the October 2004 issue #143
Buy this issue now


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recommended Posts

Start typing and press Enter to search