In April 2007 #161, Popular Woodworking Magazine Article Index

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

This jig helps you easily reverse your work for base turning.
By Garrett Lambert
Pages: 53-55

From the April 2007 issue #161
Buy this issue now

Properly finished bowls never reveal how the turner mounted them. However, traditional methods for reversing a bowl to turn the base involve a lot of fuss and bother. Cole Jaws, for example, require cranking at least 48 hex screws for each use (not to mention the aggravation of having to scrabble in the shavings for dropped screws).

Leslie Longworth must have been aggravated, too, because he did something about it. Two decades ago he conceived an ingenious self-centering scroll chuck that does the reversing job fast and elegantly. Unfortunately, it attracted little interest, perhaps because it appears complicated. His instructions were incomplete, because he was able to write only the first of two intended articles on its construction before passing away.

However, with a little imagination, the first article contains enough information to not only make his chuck but to develop it further.

From the April 2007 issue #161
Buy this issue now


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recommended Posts
0

Start typing and press Enter to search