Reindeer parts | Popular Woodworking Magazine
 In American Woodworker Blog

To make that Reindeer:

Basically, just four different kinds of parts, you'll need to make two of the front and back legs

a body from that 1×6

Antlers, note the grain direction.   Use a 3/8s round-over bit on both sides, the notch is cut to fit the notch in the body

rear leg, the notch at the back is about 3/8", round over on the outside only

front leg,  again, just round over the outside edges.   

Recommended Posts

Start typing and press Enter to search