In American Woodworker Blog, Techniques

We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

 

PWE150510_QAfull

Click to enlarge.

Q: By accident, I left a pressure-treated 2×4 on my spotless tablesaw for a couple of days. Big mistake! What can I do to remove the rust it left behind?

A: Here is a fast and simple technique for removing light rust. Pull out your random-orbit sander and cut a square about the size of your disc from a nonwoven abrasive pad. A green or dark-red 1/4-in.-thick Scotch-Brite pad is the right coarseness. The dark-red pads will last longer than the green ones. If your sander uses hook-and-loop discs, remove the sandpaper and press right down on the pad. If your sander has a smooth bottom for pressure-sensitive paper, put on a piece of coarse (60 to 80 grit) sandpaper first.

Before you begin sanding, unplug your saw and apply a lubricant to the rusty area with a paper towel. Mineral spirits or WD-40 work well,but put on no more than a very light coat.

Now, put on some eye protection. Turn on the sander and exert just enough pressure to keep the pad in place. The rust should be gone in a matter of seconds.

If this doesn’t do the trick, you’ve got two more options. First, try a light-duty rust remover as an alternative lubricant. If that doesn’t work, switch to a more abrasive pad or a sandpaper disc (220 grit or higher). Again, apply a thin coat of lubricant. Take it easy with sandpaper, because you will be removing a small amount of metal along with the rust.

When the rust is gone, apply a coat of furniture paste wax to your saw right away to prevent it from rusting.


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

Recommended Posts
0

Start typing and press Enter to search