This clip is from the DVD included with the book "Puzzle Boxes" where author Jeff Vollmer shows you how to cut a 'joiner' piece and two shoulders to support the lid for a puzzle box. Then he reviews all of the parts and shows how they are put together to make a completed puzzle box.

Glen D. Huey shows you a quick and easy way to layout and cut cabriole legs using very few tools. These legs are part of a Lowboy project featured in the June 2010 issue of Popular Woodworking Magazine.

Marc Spagnuolo (a.k.a. The Wood Whisperer) shows you the basics of using flush trim bits in your router to create burn-free edges, and how these bits can improve your work.

This behind-the-scenes video was filmed during the photo shoot for the November 2009 article "Turning for Furniture Makers", and you'll get to hear about why Kevin Glen Drake uses a skew chisel and watch him turn a chisel handle.

Breadboard ends are a traditional method of keeping large panels (such as tabletops and chest lids) flat. But, you don't need to use traditional methods to make them. Senior Editor Glen D. Huey shows you how to easily make great-looking breadboard ends using a router, one bit and a few scraps of wood.

Marc Spagnuolo (a.k.a. The Wood Whisperer) walks you through the process of pillowing the ends of ebony pegs for Greene & Greene pieces. From the August 2009 issue of Popular Woodworking.

Bellflowers and stringing inlay are just two eye-catching features of fine Federal furniture. Add cuff banding and you’ll draw attention to the ankles, too. Rob Millard shows you how in this new video.

In the June 2009 issue of Popular Woodworking Bob Lang shows you how to build a "No-nonsense Router Table." In this video, he shows you how to inset a router base plate using a very simple method.

Watch bodger Don Weber split stock from a log, and listen to him explain why you might actually want to, too.

Senior Editor Glen D. Huey explains why he sets his jointer knives at a slant and then shows you how to make a spring joint for edge joining using this method. This video is complimentary to the April 2009 article "Three Ways to Make Edge Joints."